Search results for: 'tg:rebate521 frog-x x x termin whatsapp gate long'

24 V DC chain barrier post with gearmotor and built-in control panel. Learn More

RIY077 is a tri-lobe manual release key. It is used to open most Came sliding gate motor manual release covers. Once inside the sliding gate release compartment, there is a yellow knob to turn.  It also fits the manual release mechanism on Came FROG underground motor systems fitted with the A4365 release. These keys are sold singly, or in a box of ten. 

Learn More

Click "Customize" to view all spare part for these products. For additional help, please contact 01491 680500

Learn More

ATS30AGS - 801MP-0050 Irreversible telescopic 230 V gearmotor for swing gates with C Max. 200 mm with up to 3 m leaves that weighs up to 400 kg.

Motor Features: Time of run	Motor Voltage: 230v
Max Length: 3m	Max Weight: 400Kg

 

CAME Connect	European Standards

Learn More

ZA3P Multifunction control panel for two-leaved swing gates, with limit-switch control and slow-down speed adjusting.

Control Panel Features:  Limit-Switch

Motor Voltage: 230v

 

CAME Connect	European Standards

Learn More

Operator with 230 - 400 V motor, featuring a control board, on-board radio decoding and mechanical limit-switches for sliding gates weighing up to 3500 kg that are up to 17-m long.

Motor Features: Encoder	Motor Voltage: 230v Three Phase
Max Length: 17m	Max Weight: 3500Kg

 

Three-Phase	European Standards

Learn More

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913

Learn More

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

Learn More

The VD963A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

Learn More

Operator with 24 V motor, featuring a control board with dip-switch settings, on-board radio decoding, movement and obstruction-detection control for sliding gates weighing up to 400 kg that are up to 10-m long

Motor Features: Encoder	Motor Voltage: 24v
Max Length: 10m	Max Weight: 400Kg

 

CAME Connect	European Standards

Learn More

Learn More

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

Learn More

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

Learn More

RIA043 - Gate Hooking Bracket

Learn More

A.K15   Realtime keypad

Functions: Relay1 - 1000 codes Relay2 - 100 codes Relay time 1sec to 24hrs Hold open on Relay1 50 visitor codes Real time clock enable 3 settings for key backlight 3 special solid state outputs

Learn More

119RIA047 is the manual release handle used on Came underground gate systems that have the A4364 fitted. This is the low security release mechanism. The release handle can be inserted at the base of the gate from either side of the gate. When inserted, turn the handle by about 120 degrees. When unlocked, the gate is disengaged from the underground drive.

Learn More

ZL65 Control panel for one or two-leaf swing gates, with programming display, self-diagnosing safety devices and on-board radio decoding.

Control Panel Features:  Encoder

Motor Voltage: 24v

 

CAME Connect	European Standards	Encoder Motor

Learn More

A4370 Drive lever for openings of up to 140° and gate leaves of max. 2 m in length.

Learn More

FL180    -    Chain driven 180° adaptor for openings of up to 180° and gate leaves of max. 2 m in length.

Learn More

801XA-0040    -    Cog driven 180° adaptor for openings of up to 180° and gate leaves of max. 2 m in length.

Learn More