Search results for: 'tg:sally530 good probe ani secur deciphering the tuned dailyfx'

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

VY350w    Waterproof locking gate magnet

VY500f   Waterproof gate locking magnet

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

Antenna tuned at 433.92 MHz.

Antenna tuned at 868.35 MHz.

Antenna tuned at 433.92 MHz.

Antenna tuned at 868.35 MHz.

Two way sprung loaded keyswitch. High security euro-cylinder. 

Used for hold to run applications such as roller shutter opening and closing. Hold to run is also required for automation where safety is critical, and the operator is required to to have visual contact with the risk zone.

A.G64   call activation relay on GSM network

A.G64   call activation relay on GSM network

119RIA047 is the manual release handle used on Came underground gate systems that have the A4364 fitted. This is the low security release mechanism. The release handle can be inserted at the base of the gate from either side of the gate. When inserted, turn the handle by about 120 degrees. When unlocked, the gate is disengaged from the underground drive.

TOP44FGN is a fixed code remote with four buttons transmitting on 433MHz. Note the black ring around the black buttons; any other coloured ring is not compatible. It not a style thing! Each button can be have a code cloned onto it by a compatible remote. 

Reads cards and tags on Manchester protocol, such as Came TST01, TAG, or PCT. The selector sends the data to a control panel or card processor. Both processing device will need a R700 card to comunicate with the reader. The selector does not store any data, so data cannot be stollen with the reader, the reader can be changed without loosing data, and the gate cannot be activated from the wires to the reader.

There is a blue backlight behind the sensitive area. 

Flush mount SEL options can be fitted in the CSS or CSSN posts.

Click here to view SELR1BDG manual

Two-channel 433.92 MHz standalone receiver. Housing is IP54 (internal). 12 to 24 V ac/dc. Stores up to 50 remotes. Compatible with TOP, TAM, ATOMO D, TWIN and TTS coding.

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable.