Search results for: 'tg:sally530 good power ac4n secur deciphering the tuned dailyfx'

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

Control card kit for operating during power outages and for recharging batteries, with battery housing

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

White painted aluminum 90 x 60 mm, complete with internal reinforcement, hollow cover profiles and shockproof rubber profile. Length: 4220 mm.

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

Antenna tuned at 433.92 MHz.

Antenna tuned at 868.35 MHz.

Antenna tuned at 433.92 MHz.

Antenna tuned at 868.35 MHz.

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

VY350w    Waterproof locking gate magnet

VY500f   Waterproof gate locking magnet

Two way sprung loaded keyswitch. High security euro-cylinder. 

Used for hold to run applications such as roller shutter opening and closing. Hold to run is also required for automation where safety is critical, and the operator is required to to have visual contact with the risk zone.

119RIA047 is the manual release handle used on Came underground gate systems that have the A4364 fitted. This is the low security release mechanism. The release handle can be inserted at the base of the gate from either side of the gate. When inserted, turn the handle by about 120 degrees. When unlocked, the gate is disengaged from the underground drive.

FTL-P   Complete kit for a pair of swing gates weighing up to 200 kg per leaf / max width 2 m

Intensive Duty	CAME Connect	European Standards	Encoder Motor