Search results for: 'tg:rebate567 hot to calculate low size for good tiomarkets'

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

FROG-A24E Irreversible underground 24 V gearmotor with adjustable leaf-closing for swing gates with up to 3.5 m leaves that weighs up to 400 kg.

CAME Connect	European Standards	Encoder Motor

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

Complete kit for a single swing gate weighing up to 400 kg / max width 3.5m

Intensive Duty	CAME Connect	European Standards	Encoder Motor

Complete kit for a pair of swing gates weighing up to 400 kg / max width 3.5m

Intensive Duty	CAME Connect	European Standards	Encoder Motor

119RIA047 is the manual release handle used on Came underground gate systems that have the A4364 fitted. This is the low security release mechanism. The release handle can be inserted at the base of the gate from either side of the gate. When inserted, turn the handle by about 120 degrees. When unlocked, the gate is disengaged from the underground drive.

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

The VD963A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

FTL20DGC - 801MB-0080 Irreversible 24 V gearmotor featuring a control board with dip-switch settings, on-board radio decoding with C Max. 150 mm for swing gates with up to 2 m leaves that weighs up to 200 kg

CAME Connect	European Standards	Encoder Motor

FTX20DGS - 801MB-0050 Irreversible 24 V gearmotor with with C Max. 150 mm for swing gates with up to 2 m leaves that weighs up to 200 kg.

CAME Connect	European Standards	Encoder Motor

FTX20DLS - 801MB-0120 Irreversible 24 V gearmotor with hinged transmission-arm with C Max. 250 mm for swing gates with up to 2 m leaves that weighs up to 200 kg

CAME Connect	European Standards	Encoder Motor

FROG-X Irreversible underground 24 V gearmotor with brushless 3 phase motor. For gates with up to 3.5 m leaves weighing up to 400 kg.

CAME Connect	European Standards	Encoder Motor

Feature rich GT8 barrier kit for road widths of up to 6m. There are two GT barrier frame sizes. GT4 covers roadways up to 5m with an oval arm. GT8 covers roads up to 7.6m with a one or two part hexagonal arm. Feature rich sets include arm and cabinet lights.

CAME Connect	European Standards

FTX20DLC - 801MB-0110 Irreversible 24 V gearmotor featuring a control board with functions display, on-board radio decoding and hinged transmission arm with C Max. 250 mm for swing gates with up to 2 m leaves that weighs up to 200 kg

CAME Connect	European Standards	Encoder Motor