Search results for: 'tg:rebate521 tabs about free termin'

RIY038 - Limit Switch Tabs

Click "Customize" to view all spare part for these products. For additional help, please contact 01491 680500

RIE205 - Supply Terminal / Fuse Housing

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

FTX-S   Complete kit for a single swing gate weighing up to 200 kg per leaf / max width 2 m

Intensive Duty	CAME Connect	European Standards	Encoder Motor

FTX-P   Complete kit for a pair of swing gates weighing up to 200 kg per leaf / max width 2 m

Intensive Duty	CAME Connect	European Standards	Encoder Motor

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

119RIA047 is the manual release handle used on Came underground gate systems that have the A4364 fitted. This is the low security release mechanism. The release handle can be inserted at the base of the gate from either side of the gate. When inserted, turn the handle by about 120 degrees. When unlocked, the gate is disengaged from the underground drive.

DOC-I Flush fitting safety or free exit photocells 20m range. ~ Replaced With The DLX30CIP

DLX30CIP - Direct Replacement

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913

Control panel for double leaf gates, for motors with integral encoder and electro lock. The motors have motor terminals MNE. 

Click here to view ZL92 manual

VY808s    Waterproof exit button

VY808t    Wireless waterproof exit button

VY808i    Waterproof illuminated exit button

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.