Search results for: '10 into enabled telegram probe alerts dexguru'

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

CGZP Module 4 rack made of 10 x 10 mm nylon, 1m

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

Complete kit for a single swing gate weighing up to 500 kg / max width 3 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a single swing gate weighing up to 300 kg / max width 4 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a pair of swing gates weighing up to 500 kg per leaf / max width 3 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a pair of swing gates weighing up to 300 kg per leaf / max width 4 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a pair of swing gates weighing up to 300 kg per leaf / max width 7 m

CAME Connect	Encoder Motor	European Standards

ZL60 Control panel for one or two leaf swing gates with dip switch settings, built-in radio remote programming and self-diagnosis of the safety devices.

CAME Connect	European Standards	Encoder Motor

ZL65 Control panel for one or two-leaf swing gates, with programming display, self-diagnosing safety devices and on-board radio decoding.

CAME Connect	European Standards	Encoder Motor

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

Pair of surface mounted synchronized, swiveling, infrared-beam photocells rated at 12 - 24 V AC - DC and battery transmitter. Range: 10 m.

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

Complete kit for a sliding gate weighing up to 400 kg / max width 10 m

CAME Connect	European Standards

Pair of surface mounted infrared-beam photocells rated at 12 - 24 V AC - DC. Range: 10 m

Operator with 24 V motor, featuring a control board with dip-switch settings, on-board radio decoding, movement and obstruction-detection control for sliding gates weighing up to 400 kg that are up to 10-m long

CAME Connect	European Standards

A.K15   Realtime keypad

A.R23   Vehicle ID receiver