Search results for: 'connection terminal back with fuse hole'

RIE205 - Supply Terminal / Fuse Housing

Click "Customize" to view all spare part for these products. For additional help, please contact 01491 680500

88003-0070 - Photocell Hole Cover 4pcs

RID303 - Back Bracket AXO5/7

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

RID098 - Back Joint for AMICO ATI AXO KRONO

RID062 - Back Bracket for AMICO ATI AXO KRONO

R700 plugs into recent PCB's to interface card reader selectors to the control panel.

Cable for connecting the luminous cord.

Circuit board for self-diagnosing the electrical connections, 12 - 24 V AC – DC.

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

The VD963A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

Click "Customize" to view all spare part for these products. For additional help, please contact 01491 680500

CGZS Module 4 rack made of 30 x 8 mm galvanized steel with fastening holes and distancers, 1m

Reinforcement for the clamp-end. Essential for passage clearances of over 4 m.

Click "Customize" to view all spare part for these products. For additional help, please contact 01491 680500

Hearing impaired and voice synthesis moduleElectronic module with techno-polymer body, equipped with a loudspeaker used for the playing back system voice messages. It has an audio-frequency induction system for hearing aids, in the "T" position. To finish off with the hearing impaired module. When combined with the corresponding front panel, it guarantees IP54 water and dust protection.

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913

Complete kit for a sliding gate weighing up to 1000 kg / max width 20 m

CAME Connect	European Standards

Click "Customize" to view all spare part for these products. For additional help, please contact 01491 680500