Search results for: 'tg:rebate567 belt free termin strategies 22 for consistent profil'

Belt guide L = 3.02 m

CGZ Module 4 rack made of 22 x 22 mm galvanized steel, 1m

RIE205 - Supply Terminal / Fuse Housing

White painted aluminum 90 x 60 mm, complete with internal reinforcement, hollow cover profiles and shockproof rubber profile. Length: 4220 mm.

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

CGZ6 - Galvanized rack module 6 in 30 x 30 laminated steel, 1m

CGZS Module 4 rack made of 30 x 8 mm galvanized steel with fastening holes and distancers, 1m

White painted tube-section aluminum boom, with groove covering profile. Ø 100 mm, boom length: 2-6 m.

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

Operator with encoder, featuring a control board with segmented graphic display, for sectional and overhead garage doors.

Encoder Motor	European Standards

Operator with encoder, featuring a control board with segmented graphic display, for sectional and overhead garage doors.

Encoder Motor	European Standards

Operator with encoder, featuring a control board with segmented graphic display, for sectional and overhead garage doors.

Encoder Motor	European Standards

Operator with encoder, featuring a control board with segmented graphic display, for sectional and overhead garage doors.

Encoder Motor	European Standards

Click "Customize" to view all spare part for these products. For additional help, please contact 01491 680500

DOC-I Flush fitting safety or free exit photocells 20m range. ~ Replaced With The DLX30CIP

DLX30CIP - Direct Replacement

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913