Search results for: 'tg:rebate521 tabl about free tradit'

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

Learn More

AGT is the handset intercom characterized by the essential lines and ergonomic handset with magnetic hang-up that eliminates the risk of falling or incomplete contact.
Soft touch buttons for the X1 version, traditional mechanical buttons in the 200 version, with white indicator LEDs. In the EVO version, up to 6 intercom calls can be programmed.

Learn More

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

Learn More

DLX30CEP is Came's latest traditional square surface photobeam. It replaced DELTA-E and DOC-E. 

Learn More

DLX30CIP is Came's latest traditional square flush photobeam. It replaced DELTA-I and DOC-I. 

Learn More

119RIA047 is the manual release handle used on Came underground gate systems that have the A4364 fitted. This is the low security release mechanism. The release handle can be inserted at the base of the gate from either side of the gate. When inserted, turn the handle by about 120 degrees. When unlocked, the gate is disengaged from the underground drive.

Learn More

Post with counter-weight and chain latch. for: CAT-X – CAT-X24 - CAT-X110 - CAT-X24110 Learn More

Genovese-type, 9 mm chain for clearances of up to 8 m.

Learn More

24 V DC chain barrier post with gearmotor and built-in control panel. Learn More

230 V AC chain barrier post with gearmotor and built-in control panel.

Learn More

VD908  Adjustable mini-loop exit sensor

Specification: 19mm diameter sensor 22m cable length 8-40V dc  or 8-28V ac Iq = 1.6mA, Idetect = 30mA Module size 25 x 39 x 52mm (excl conn) Environmental rating – IP65 1A @ 30Vdc volt free contacts Operating temp -35° C to 74° C

New mini-loop kit with adjustable sensitivity module and new probe 

Learn More

DOC-I Flush fitting safety or free exit photocells 20m range. ~ Replaced With The DLX30CIP

DLX30CIP - Direct Replacement

Learn More

FA.T80   CoBRA programmable beam

Specification: 7 fixed ranges plus full adjustment 10-30V dc   10-24V ac Iq = 65mA, Idetect = 28mA Dimensions 37 x 36 x 108mm Environmental rating – IP65 0.8A @ 30Vdc volt free N/O or N/C Operating temp -10° C to 60° C

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

Learn More

AGT is the handset intercom characterized by the essential lines and ergonomic handset with magnetic hang-up that eliminates the risk of falling or incomplete contact.
Soft touch buttons for the X1 version, traditional mechanical buttons in the 200 version, with white indicator LEDs. In the EVO version, up to 6 intercom calls can be programmed.

Learn More

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

Learn More

FA.T80   CoBRA programmable beam

Specification: 7 fixed ranges plus full adjustment 10-30V dc   10-24V ac Iq = 65mA, Idetect = 28mA Dimensions 37 x 36 x 108mm Environmental rating – IP65 0.8A @ 30Vdc volt free N/O or N/C Operating temp -10° C to 60° C

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

Learn More

AGT is the handset intercom characterized by the essential lines and ergonomic handset with magnetic hang-up that eliminates the risk of falling or incomplete contact.
Soft touch buttons for the X1 version, traditional mechanical buttons in the 200 version, with white indicator LEDs. In the EVO version, up to 6 intercom calls can be programmed.

Learn More

AGT is the handset intercom characterized by the essential lines and ergonomic handset with magnetic hang-up that eliminates the risk of falling or incomplete contact.
Soft touch buttons for the X1 version, traditional mechanical buttons in the 200 version, with white indicator LEDs. In the EVO version, up to 6 intercom calls can be programmed.

Learn More

AGT is the handset intercom characterized by the essential lines and ergonomic handset with magnetic hang-up that eliminates the risk of falling or incomplete contact.
Soft touch buttons for the X1 version, traditional mechanical buttons in the 200 version, with white indicator LEDs. In the EVO version, up to 6 intercom calls can be programmed.

Learn More

Perla is the hands-free wall-mounting intercom, characterized by the central blue backlit ring nut that allows to activate the many functions available.

Learn More