Search results for: 'loop wire'

VD909   Mini-loop exit sensor

'Dynamite' vehicle sensors are the market leading detectors. No loops to cut. Self setting. The no brainer alternative to traditional exit loops.

VD909L   Mini-loop exit sensor

Slimline version of 'Dynamite' vehicle sensors with 3 sensitivity adjustments.

100m drum of single core rubber loop cable for use with: VD907, VD906, VD955 detectors

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

Keypad with 12 keys for code entry.  The codes are held in the compatible controller. Connection is made on a 2 core cable to the controller.

Click to view SELT1 manual

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

The VD963A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913

A.Gtag   Unique ID vehicle tag 

The Gtag is a plug in USB device that transmits a unique ID to a receiver A.R22 in the access control system. Each receiver can save 340 Gtag's.

A.Gtag   Unique ID vehicle tag 

The Gtag is a plug in USB device that transmits a unique ID to a receiver A.R22 in the access control system. Each receiver can save 340 Gtag's.

Reads cards and tags on Manchester protocol, such as Came TST01, TAG, or PCT. The selector sends the data to a control panel or card processor. Both processing device will need a R700 card to comunicate with the reader. The selector does not store any data, so data cannot be stollen with the reader, the reader can be changed without loosing data, and the gate cannot be activated from the wires to the reader.

There is a blue backlight behind the sensitive area. 

Flush mount SEL options can be fitted in the CSS or CSSN posts.

Click here to view SELR1BDG manual

A.R22   Vehicle ID receiver

A.R23   Vehicle ID receiver

Complete kit for a pair of swing gates weighing up to 400 kg per leaf / max width 5 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a single swing gate weighing up to 400 kg / max width 5 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a single swing gate weighing up to 500 kg / max width 3 m

CAME Connect	Encoder Motor	European Standards

Complete kit for a pair of swing gates weighing up to 500 kg per leaf / max width 3 m

CAME Connect	Encoder Motor	European Standards