Search results for: 'affordable made https sipp.pa kendari.go.id delta e we agen96'

DOC-E Surface fitting safety photocells 20m range ~ Replaced With The DLX30CEP

DLX30CEP - Direct Replacement

DLX30CEP is Came's latest traditional square surface photobeam. It replaced DELTA-E and DOC-E. 

FROG-CFNI Foundation box made of AISI 304 steel, with release latching lever, gate fastening brace and screw for adjusting the opening limit point.

CGZP Module 4 rack made of 10 x 10 mm nylon, 1m

CGZ Module 4 rack made of 22 x 22 mm galvanized steel, 1m

CGZS Module 4 rack made of 30 x 8 mm galvanized steel with fastening holes and distancers, 1m

DLX30CIP is Came's latest traditional square flush photobeam. It replaced DELTA-I and DOC-I. 

Sensitive safety edge made of rubber, with mechanical contact.L = 1,500 mm.

Sensitive safety edge made of rubber, with mechanical contact.L = 1,700 mm.

Sensitive safety edge made of rubber, with mechanical contact.L = 2,000 mm.

Sensitive safety edge made of rubber, with mechanical contact.L = 2,500 mm.

Hidden module with front panel.Module with techno-polymer body and blind front panel made of natural anodized satin aluminum. Impact protection degree IK07 and water and dust protection degree IP54.

Make sure you choose the correct number of casements and manual releases so it matches the number of motors that you need.

Use this tool to build a FROG kit of your choice:

-Motor and Control Panel. The panels match the chosen motor.

-Manual release type. Choose from lever, trilobe or custom key.

-Remotes. Choose between 2 button and 4 button, fixed or rolling code.

-Foundation casing. 

-Photocells. 

-Choose whether you need a radio card and/or antenna.

Keypad with 12 keys for code entry.  The codes are held in the compatible controller. Connection is made on a 2 core cable to the controller.

Click to view SELT1 manual

CGZ6 - Galvanized rack module 6 in 30 x 30 laminated steel, 1m

A.Gtag   Unique ID vehicle tag 

The Gtag is a plug in USB device that transmits a unique ID to a receiver A.R22 in the access control system. Each receiver can save 340 Gtag's.

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

Circuit board for self-diagnosing the electrical connections, 12 - 24 V AC – DC.