Search results for: '【Tg:Rebate521】-forex factory: an in-depth guide for novices - LinkedIn'

Belt guide L = 3.02 m

VD908  Adjustable mini-loop exit sensor

New mini-loop kit with adjustable sensitivity module and new probe 

FROG-PC Foundation box in steel with cataphoresis treatment, complete with unlocking lever, fixing bracket to the gate and screw for adjusting the limit switch point in opening

FROG-CFN Foundation box in steel with cataphoresis treatment, complete with unlocking lever, fixing bracket to the gate and screw for adjusting the limit switch point in opening

Control board for decoding and access-control management via keypad selectors. R800 plugs into recent control panels.

The VD961A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

The VD963A, known as the Magna Sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably. The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.

Ethernet Gateway module with built-in radio, with the CAME CONNECT dedicated system (002RSE module included). For controlling up to five slave modules.

CGZ6 - Galvanized rack module 6 in 30 x 30 laminated steel, 1m

Make sure you choose the correct number of casements and manual releases so it matches the number of motors that you need.

Use this tool to build a FROG kit of your choice:

-Motor and Control Panel. The panels match the chosen motor.

-Manual release type. Choose from lever, trilobe or custom key.

-Remotes. Choose between 2 button and 4 button, fixed or rolling code.

-Foundation casing. 

-Photocells. 

-Choose whether you need a radio card and/or antenna.

A.Gtag   Unique ID vehicle tag 

The Gtag is a plug in USB device that transmits a unique ID to a receiver A.R22 in the access control system. Each receiver can save 340 Gtag's.

433,92 MHz plug-in radio frequency card.

868.35 MHz plug-in radio frequency card.

A4370 Drive lever for openings of up to 140° and gate leaves of max. 2 m in length.

FL180 Chain driven transmission lever for openings of up to 180° and gate leaves of max. 2 m in length.

Semi-oval section barrier arm in white aluminum alloy.  A yellow rubber bump strip is fitted in a groove under the arm. Arm length is 4m for 3.75m opening.

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913

868.35 MHz surface-mounted, 12-key radio keypad selector, with blue backlight, 25 savable codes and password to access the programming mode. Settable in Rolling Code or Fixed Code mode.

Irreversible gearmotor with encoder for swing gates measuring up to 1.8 m in length per leaf.

CAME Connect	European Standards