Search results for: '【Tg:Alba5300】-Top 10 Forex Brokers In The World 2024 - YouTube'

FROG-PC Foundation box in steel with cataphoresis treatment, complete with unlocking lever, fixing bracket to the gate and screw for adjusting the limit switch point in opening

FROG-CFN Foundation box in steel with cataphoresis treatment, complete with unlocking lever, fixing bracket to the gate and screw for adjusting the limit switch point in opening

CGZP Module 4 rack made of 10 x 10 mm nylon, 1m

Auxiliary contacts unit for detecting the boom position

Antenna tuned at 433.92 MHz.

Antenna tuned at 868.35 MHz.

Make sure you choose the correct number of casements and manual releases so it matches the number of motors that you need.

Use this tool to build a FROG kit of your choice:

-Motor and Control Panel. The panels match the chosen motor.

-Manual release type. Choose from lever, trilobe or custom key.

-Remotes. Choose between 2 button and 4 button, fixed or rolling code.

-Foundation casing. 

-Photocells. 

-Choose whether you need a radio card and/or antenna.

FA.T80   CoBRA programmable beam

Programmable range photobeam, one side only. Set range on DIP switches, or fully adjustable. 

The VD907 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

The VD906 vehicle loop detector allows "free passage" of vehicles passing overhead. These units are an installer favourite due to their small size and being self setting it's easy to install.

Ethernet Gateway module with built-in radio, with the CAME CONNECT dedicated system (002RSE module included). For controlling up to five slave modules.

The VD955 can be used as either a safety loop or free exit probe detector. It should not be used as a safety loop if used with a Free Exit Probe. 

The VD955 includes a VD.CI Interface board, to work with most gate automation control panels.

• 10-30V ac/dc
• Selectable for full loop or exit sensor
• Selectable fail safe (presence) or fail secure (exit)
• 10 sensitivities
• 4 frequencies
• Contact closure/opening time delay

Control board for decoding and access-control management via keypad selectors. R800 plugs into recent control panels.

Complete kit for a sliding gate weighing up to 400 kg / max width 10 m

CAME Connect	European Standards

A.Gtag   Unique ID vehicle tag 

The Gtag is a plug in USB device that transmits a unique ID to a receiver A.R22 in the access control system. Each receiver can save 340 Gtag's.

LB180 is an interface circuit board to connect two batteries to a ZLJ24 control panel. The LB180 will keep the batteries charged while mains power is applied. It will switch over to the batteries when the mains power fails. 

LB180 takes two 12V batteries. The battery size depends on the anticipated use while running on battery, and the overall time the power is off. In UK, we can expect power outages to be about 10 minutes, but recent storms have seen several days outage.

Barrier arm for G6000 cabinets, white 100mm diameter. This arm fits the G0605 arm clamp. The G0461 reflective strips are recommended.

The VD.CI is designed to accept a plug-in vehicle detector on one side and accept the appropriate wires through the terminal block on the other. This device is designed for detectors that have a solid state output but need a single relay output.

For use with: VD940, VD955, VD913

Two-channel 433.92 MHz standalone receiver. Housing is IP54 (internal). 12 to 24 V ac/dc. Stores up to 50 remotes. Compatible with TOP, TAM, ATOMO D, TWIN and TTS coding.