Search results for: 'tg:kaia770 10 buri for track singl telegram good'

Two way sprung loaded keyswitch. High security euro-cylinder. 

Used for hold to run applications such as roller shutter opening and closing. Hold to run is also required for automation where safety is critical, and the operator is required to to have visual contact with the risk zone.

119RIA047 is the manual release handle used on Came underground gate systems that have the A4364 fitted. This is the low security release mechanism. The release handle can be inserted at the base of the gate from either side of the gate. When inserted, turn the handle by about 120 degrees. When unlocked, the gate is disengaged from the underground drive.

The SEL-B communicates with your phone using Wifi. Download the AUTOMATION BT app and operate the gate from your phone. If enabled, your phone can open the gate automaically when it is in range.

The SEL-B takes a multicore cable. Power is 12 or 24V ac/dc. The package is IP54 .     Click to view Bluetooth Selector Manual

RIY077 is a tri-lobe manual release key. It is used to open most Came sliding gate motor manual release covers. Once inside the sliding gate release compartment, there is a yellow knob to turn.  It also fits the manual release mechanism on Came FROG underground motor systems fitted with the A4365 release. These keys are sold singly, or in a box of ten. 

Reads cards and tags on Manchester protocol, such as Came TST01, TAG, or PCT. The selector sends the data to a control panel or card processor. Both processing device will need a R700 card to comunicate with the reader. The selector does not store any data, so data cannot be stollen with the reader, the reader can be changed without loosing data, and the gate cannot be activated from the wires to the reader.

There is a blue backlight behind the sensitive area. 

Flush mount SEL options can be fitted in the CSS or CSSN posts.

Click here to view SELR1BDG manual

RIA013 - Gearmotor Box

RIA014 - Lower Flange

RIA015 - Slow Shaft

RIA016 - End Screw

RIA046 - Transmission Lever

RIA083 - Encoder Magnet

RIA084 - Encoder Device

RIA036 - Transmission Chain

RIA100 - Protective Cover

Heater kit with thermostat.

RIA120 - Oil Seal/Cap

RIA009 - Foundation Box Cover

RIA022 - Foundation Box Screw Pack

RIA029 - Foundation Box/Cover

RIA042 - Release Hooking Lever