|
Functions:
|
Technical features:
|
A.R22 Vehicle ID receiver
This vehicle ID receiver will open a gate or door to vehicles carrying a valid long range radio frequency ID tag. The receiver can be connected to and powered from all known control panels. The set is supplied with two pre-programmed ID tags.
The receiver controls the gate through two relays, one for opening and another to close. Gates and barriers with auto-close function enabled will only use the OPEN relay output. A blue LED indicates a vehicle ID tag is within the zone.
Mount the receiver in a plastic waterproof housing at least 1.5m above ground for good RF reception. There is no sensitivity adjustment or any other serviceable parts inside the receiver.
To add an ID tag, power the receiver and plug in the Gtag. Press the P1 learn button on the receiver; the blue LED lights. The blue LED will light, then flash twice, then stay on.
Tags cannot be cleared individually, but the whole memory can be cleared. Press the P1 learn button for 5 secs. The blue LED flashes 5 times to confirm deletion.
The simplest wiring is for gate openers and barrier panels with auto-closing. The receiver has an open relay and a close relay, both producing a momentary pulse. The CLOSE output is not normally required, but could be used to close the gate sooner than the time delay set. The wiring below shows connection to a controller with auto-close enabled.
Multi-user entrances on private car parks or gated communities may have several users entering at the same time. The control panel must have timed closing and an open input. If only a combined open and close input is available, the additional relay shown for garage door openers will be necessary.
